yaksplat 46 Posted December 11, 2020 Share Posted December 11, 2020 If the server disconnects, and the pi is headless, is there any way to force a reconnect without logging in? Or are you better off just rebooting the pi if there's no session found? Link to post Share on other sites
Luke 26175 Posted December 12, 2020 Share Posted December 12, 2020 You should be able to just leave the app as it is without doing anything. Link to post Share on other sites
yaksplat 46 Posted December 12, 2020 Author Share Posted December 12, 2020 (edited) So far that's not working. It vanishes from the active session list. I may end up just doing a session query on some interval and then sending a reboot if it comes back with an empty session list for that device. Edited December 12, 2020 by yaksplat Link to post Share on other sites
Luke 26175 Posted December 12, 2020 Share Posted December 12, 2020 Ok so yes if you want to remote control it, then you will need to intervene in order to re-establish the connection required for that. Link to post Share on other sites
yaksplat 46 Posted December 17, 2020 Author Share Posted December 17, 2020 Turns out that if you do a Get on the Session, it forces a reconnect and the Pi appears as an active client again. If it's done before each POST to play then the post command causes the audio to play immediately. Link to post Share on other sites
yaksplat 46 Posted January 2 Author Share Posted January 2 Put this in another thread, but it fits better here, and for searching reasons as well Occasionally Theater will not play back. The session is still there, you can do a post to play a song, but it will only give out a droning hum with no proper response. At this point a reboot is the only thing that fixes the issue. Link to post Share on other sites
Luke 26175 Posted January 3 Share Posted January 3 I would try 3.0.14 and see if that's any different. thanks. Link to post Share on other sites
yaksplat 46 Posted January 3 Author Share Posted January 3 Is there a good way to force an update to theater over ssh? Link to post Share on other sites
Luke 26175 Posted January 3 Share Posted January 3 You just install the same way you did originally, over the top of your existing version. Link to post Share on other sites
yaksplat 46 Posted January 11 Author Share Posted January 11 3.0.14 will still eventually stop responding as well. Link to post Share on other sites
Luke 26175 Posted January 25 Share Posted January 25 Ok we'll take a look at it. Thanks. Link to post Share on other sites
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now