same show, 2 different channels

[muzicman0 84]

How does Emby recording engine handle this?  Cox is changing their channel lineup, but for a small amount of time, some channels may be duplicated in the Guide Data.  Will it pick one?  What if 1 is SD, and one is HD?  etc.

[Luke 42081]

Hi, we probably still have room for improvement with this type of scenario. For now you may want to configure your series recording to the specific channel, or remove the SD channel from your tuner source.

[muzicman0 84]

The problem is that Cox is moving away from SD channels.  In the past, all HD channels are above 1000, while SD is below.  So, right now, (I think) ALL channels are HD.  But I don't know when the channels above 1000 are actually going away, and I am not 100% sure that all channels below 1000 are actually HD.  The few I checked are though.  In any case, I was hoping that for the short term, I could leave them both mapped until the changes happen.  Sounds like I will need to manually check all the channels below 1000 that I use and see if they are in fact HD.  Not a huge deal, just a bit of a pain!