ipv6 - do you have to enable it?

[icsy7867 8]

My ISP does not give out public IPv4 addresses, but they do hand out ipv6 addresses like crazy.

 

I have my own pool of ipv6 addresses, and I would like to get emby listening on ipv6.  Currently it does not seem like emby is listening on the ipv6 stack.

 

ping6 google.com - Works fine

 

I can also ping the emby servers ipv6 address throughout my internal network.  but launching:

[ipv6_Address]:8096 fails to load.

 

Is there any setting or a conf file i can check to make sure ipv6 is enabled?

[Luke 42078]

emby already supports ipv6, however we do this with dual-mode sockets, and it is my understanding that freebsd does not support this.

[icsy7867 8]

Noooooo

 

I was hoping I could use a jail so that it would have direct access to my processor cores.  I guess I can give a VM a whirl and see how well it does with transcoding.  Virtual Cores just aren't the same...

 

Thanks fo responding so quickly, I am glad I asked instead of banging my head against this for a few hours.