Question about HDHR firmware

[pir8radio 1312]

So I'm switching to two HDHomeruns for my live tv.  They are not being detected by emby like they used to be...   I even tried entering the tuner ip manually yet they don't show up in the list of tuners...    Yet from the web browser on the same emby server i can tune into a channel just fine.    The only change is that my server is bound to 127.0.0.1  But I didn't think this was for the tuner search as well?  Is it?   Bind to is just for the emby web server right? 

[Luke 42078]

If the automatic detection doesn't find it, you can always manually enter the address.

[pir8radio 1312]

If the automatic detection doesn't find it, you can always manually enter the address.

 

I did, but i still dont see the list of "available tuners"   or was that removed?    It used to say Tuner 0, Tuner 1, Tuner 2 and their status.      I might have to submit some logs... 

[Luke 42078]

Sounds like it.

[pir8radio 1312]

Well thats a little embarrassing,  Its working..   It just looks like you removed the list of available tuners on the live tv tab in the dashboard...   Sorry to waste everyone's time.  

[Luke 42078]

No that hasn't been removed.

[pir8radio 1312]

No that hasn't been removed.

 

Humm....  I am watching live tv, and the Tuner Devices screen shows no available tuners below the "Refresh Guide" button like I remember..  Should I be looking elsewhere?

 

[Luke 42078]

Best thing to do is provide the info requested in how to report a problem. thanks !

[maegibbons 1287]

Yes - that section is still there for me on yesterdays beta.

 

What HDHR model and firmware are you running?

 

Krs

 

Mark

[pir8radio 1312]

Yes - that section is still there for me on yesterdays beta.

 

What HDHR model and firmware are you running?

 

Krs

 

Mark

 

 

Thanks for reminding me to check the firmware of the HDHomerun, that was the issue...   Again embarrassing....  I should know better...