Unable to add EMBY user to Synology

[sobeitjedi 4]

Hi.

Trying to update my Synology DS215j to the latest DSM and therefore update Emby server to the latest version too.

During the process, Synology renamed the emby user account to emby_XXX (or similar). Now, when 'm trying to setup Emby libraries, it cannot find my shares on the server. I've tried deleting the emby_XXX account on Synology so I can add just "Emby" as the user account, but I get a message saying that this account already exists (even though it's not listed in User & Groups).

Can anyone please help/advise?

Thank you. 

[kaj 316]

Did you check this topic before updating?

 

 

 

[sobeitjedi 4]

No, I didn't visit this forum until after I encountered upgrade issues. 

What do I need to do? 

[FrostByte 5392]

Since you have done most of it already the parts you may still be interested in are recovering Emby data from your DSM 6 information (putty) and the last little part about setting share permissions so you can add libraries

- stop Emby
- remove emby_pkg user and video group
- enable admin account if needed

- enable ssh in Synology settings (Terminal & SSH menu)

Not shown in video:
- connect with Putty to Synology, login with admin user and get root rights with: sudo -i

- copy files from old Emby share to new data location: 
cp -rv /volume1/Emby/* /volume1/@appdata/EmbyServer

- adjust owner from copied files: 
chown -R emby:emby /volume1/@appdata/EmbyServer
- close putty

Shown again in video:
- From Control Panel go to Shared Folder and edit each share that is used by Emby Server.  Click the share, then EDIT, go to permission tab, select System internal user from drop down,
grant emby user read/write access.
 
- start Emby

However, if you just need to add libraries and want to forget all the putty stuff here's another guide

 

[Carlo 4561]

@sobeitjedi, if you run into any problems send me a PM here on the forums and I can remote in and give you a hand.

Carlo

[sobeitjedi 4]

Hugh thanks for the replies - I'm finally back up and running.

All I needed to do was to add the permission in this new area, as mentioned above in this thread

Many thanks. : 

 

[Luke 42078]

Thanks for the feedback.