QNap Setup Issues

[inFusion 0]

Good Day everyone!

First time user of Emby server, and running in to a few problems(I've seen a few posts here, but still can't seem to figure out what my next steps are.)

NAS Model - QNAP TS-220
Device Firmware - 4.3.3.1945 (20220303)

Emby Server Version - emby-server-qnap-mono_4.7.2.0_arm-x19

Emby Server installed no issue. I'm able to access the NAS no issue using it's Web address(192.168.xxx.xxx:8080)
When I try to open the Emby Server app(Either using the app itself on the QNAP or through an PC web browser at address 192.168.xxx.xxx:8096) I get the connection refused error message.

I have done no port forwarding on my router for port 8096, as I'm only wanting to use it on my external network for the time being. 

I saw that one of the users @Luke had mentioned something about the Emby Server and the Qnap fighting over SSL, and I need to go into the Emby app and change it, but if I can't open the app, how do I go about doing that.

Any insight is greatly appreciated!

[Luke 42077]

Hi, did you follow that install instructions on our website?