shsharpe 0 Posted May 27, 2019 Share Posted May 27, 2019 I've been using Emby on my Shield for a fair while and have an issue where it takes a few seconds for the audio to start. This will also happen when I un-pause. Because of this when I un-pause I have to rewind a bit to catch the missed audio. Any idea if there is some setting causing this or have others seen the same problem? I tried Plex yesterday to compare and it does not have this issue; I prefer Emby in general but have switched to Plex until I get this issue sorted. Link to comment Share on other sites More sharing options...
ebr 14958 Posted May 28, 2019 Share Posted May 28, 2019 Hi. Is this bitstreamed audio (DD or DTS etc)? Link to comment Share on other sites More sharing options...
shsharpe 0 Posted May 28, 2019 Author Share Posted May 28, 2019 Seems it will happen if the codec is dolby+ which will cause it to transcode it seems. If I have the downmix to stereo option set it does not have the issue. Link to comment Share on other sites More sharing options...
ebr 14958 Posted May 29, 2019 Share Posted May 29, 2019 Every receiver I've ever had has muted the audio whenever a bitstreamed stream is interrupted and it takes a second or two for it to un-mute. I'm not sure what, if any, controls there are over this. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now