Option to force audio downmix/conversions during playback

[Goros 1]

I know this has been requested in the past, but it's been years (almost 7) since then, and it's not live in a usable form on Emby for Android.

There's a fundamental misunderstanding on how codecs are handled and what can and can't be passed via TOSLINK, Arc or eArc.

With an Emby for Android install on a TV - in this case, a Bravia x95j, Emby (correctly) sees that the TV can decode AAC audio in 2.0, 5.1, etc.  What it does not see is that if the TV is set for passthrough to an audio receiver or soundbar, it CANNOT PASS AAC OVER HDMI - because AAC and HDMI do not ever work together.

Then, by default, TVs will downmix this to PCM 2.0 because again - HDMI hates AAC, and Arc does not support PCM 5.1/7.1 - there just isn't enough bandwidth in TOSLINK or Arc to make it work.  While eArc CAN carry pcm bitstream 5.1/7.1 - TV's will always force AAC down to PCM 2.0 to send it via passthrough on any HDMI link.  There is no TV on the market that natively remixes AAC 5.1/7.1 to any type of multichannel format in order to pass it to another device.  It's always remixed to PCM 2.0.

Kodi has the ability to force-flag a conversion of any AAC audio to AC3 in the options - Emby's built-in option relies on a hardware detection algo that doesn't see if the codec is being sent anywhere other than the TV it's installed on.

Here's the TL;DR

Problem - no option to force AAC to AC3 conversion on a device with native AAC decode, but AAC can't be sent over HDMI if a receiver or soundbar is involved for the audio playback. PCM 2.0 is the result, 100% of the time.

Cause -

• AAC doesn't play nice with HDMI, and TOSLINK/Arc don't have the bandwidth to support it in multichannel, even if they did.
• Emby does not consider devices down the chain that might be handling audio from the TV via Arc, eArc or Toslink - only the base hardware capabilities of the device it's installed on.

Solution - instead of an "if a video uses a codec but the system Emby is installed on has incompatible hardware, force conversion to AC3" option, add an "always convert to AC3 for these codecs" option, similar to Kodi's.

             

 

Edited 4 hours ago by Goros
context clarity / grammar x2

[visproduction 369]

Goros,

My media content uses AAC audio at the highest bitrate and it always plays fine, directly to TV internal speakers using an HDMI cable.  Your system has perhaps something in between like an AV amp or the connection directly to speakers or pass through to speakers, causes some issue.  I don't use AC3 because going to a windows or TV web browser AC3 or EC3 audio always triggers a transcoding and AAC doesn't.  Why do you think your setup has AAC connection issues and my direct from server to TV has no issue?