Ratatouille 11 Posted November 4, 2021 Share Posted November 4, 2021 Now I have enable QuickSynk/VAApi( thanks to member of this board) I had NVIDIA before, I see I can use them all together in transcoding page can I do it ,should I do It, any advantage? What id the difference between QuickSync and VAAPI/? Link to comment Share on other sites More sharing options...
Luke 37113 Posted November 4, 2021 Share Posted November 4, 2021 Hi, it's two different methods to use the same graphics card. There isn't a one size fits all answer about which is better so you'll have to just try them and see how they compare with your media. When in doubt just set it to yes instead of advanced and trust the emby server defaults. Link to comment Share on other sites More sharing options...
Ratatouille 11 Posted November 4, 2021 Author Share Posted November 4, 2021 (edited) Ok, my other initial question was basically in my transcoding page I can put a check mark on everything, can they all worked together with Nvidia or I should not do that? and reconfigure my docker compose to have one or the other? Edited November 4, 2021 by Ratatouille Link to comment Share on other sites More sharing options...
Luke 37113 Posted November 4, 2021 Share Posted November 4, 2021 If you enable everything then it will be chosen based on the priority order Link to comment Share on other sites More sharing options...
Ratatouille 11 Posted November 4, 2021 Author Share Posted November 4, 2021 I start to understand, were is the priority order to be set? Link to comment Share on other sites More sharing options...
Luke 37113 Posted November 4, 2021 Share Posted November 4, 2021 Using the arrows on the right side of the list. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now