Jump to content

Cannot disable remote access


emby20180524

Recommended Posts

emby20180524

Cannot disable "remote access".

 

Public IP always shown on Dashboard page.

 

Un-checking the "Allow remote connections to this Emby Server" box on the Advanced page and clicking Save results in nag messages but "remote access" remains turned on when return to Dashboard page.

 

Link to comment
Share on other sites

emby20180524

Hi, try restarting emby server.

Attempted full reboot of the computer where Emby is installed. No improvement.

 

Emby 3.4.1.0

Debian Stretch

Link to comment
Share on other sites

Did you read the nag message when clicking save?

 

It's not a nag message. Please read it and follow the instructions. Thanks.

Link to comment
Share on other sites

emby20180524

Did you read the nag message when clicking save?

 

It's not a nag message. Please read it and follow the instructions. Thanks.

 

"Changing these values may cause instability or connectivity failures. If you experience any problems, we recommend changing the back to default."

 

There's no instability or connectivity failures. I just want the damn thing to stop serving my stuff to the whole world.

 

 

"To enable HTTPS for external connections you will nedd to supply a trusted SSL certificate ..."

 

I DON'T WANT EXTERNAL CONNECTIONS. I'M TRYING TO SWITCH IT OFF.

 

So, I did read the nag messages and they contained no valuable information.

 

What is wrong with Emby that it refuses to swich off "remote access"?

Link to comment
Share on other sites

This is happening because you must have changed the secure connections mode setting. Set it to disabled and then you should be able to save.

Link to comment
Share on other sites

emby20180524

I was able to hack around the "Allow remote connections to this Emby Server" bug by first setting "Secure connection mode" to Disabled. This released whatever was causing Emby to ignore the checkbox setting.

 

However, "Remote (WAN) access" with my IP address is still displayed on the Dashboard which suggests that Emby is still (trying to) serve out to the Internet. I have changed the port to a nonsense number to prevent hackers from obviously attacking the default Emby port. However, why is this still "on" and how is this stopped?

Link to comment
Share on other sites

emby20180524

Attempted both "Restart" from the Dashboard page and rebooting the computer entirely. No improvement. "Allow remote connections to this Emby Server" remains un-checked but Emby is still showing "Remote (WAN) access: with IP address as if its still attempting to serve to the Internet.

Link to comment
Share on other sites

Ok I think it is likely just a display issue. I'll test this out. Thanks.

Link to comment
Share on other sites

  • 1 month later...
soalokin

I can confirm the same issues as the OP. 

 

Tested with Version 3.4.1.0

 

Did the suggested workaround successfully.

Dashboard still shows Remote WAN Access IP Address.

Hopefully its just a display bug.

Will have to dig into the router logs for upnp.

 

It seems like the remote WAN is not accessible, so that is good since I have it disabled in emby.

 

Edit, This is off of windows 64 bit as well. 

Edited by soalokin
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...