Erik 120 Posted February 18, 2017 Share Posted February 18, 2017 Hi, was considered replacing my HTPC with a roku ultra for my front room (just a tv, nothing special). Just had a couple questions. 1) I looked up the suppported formats, but it says "USB supported formats" i would assume that means through the emby beta app as well, not just the usb, is that correct? From the Roku website: Video — H.264/AVC (.MKV, .MP4, .MOV), H.265/HEVC (.MKV, .MP4, .MOV); VP9 (.MKV) Audio – AAC (.MKV, .MP4, .MOV); MP3(.MP3, .MKV); WMA (.ASF, .WMA, .MKV), FLAC (.FLAC, .MKV), PCM (.WAV, .MKV, .MP4, .MOV), AC3/EAC3 (.MKV,.MP4. .MOV, .AC3), DTS (.MKV, .MP4, .MOV), ALAC (.MKV, .MP4, .MOV, .M4A) 2) Is the DTS that supported include DCA? (my emby media info for blue rays shows DCA as the codec but profile DTA) So, if 99% of my media i used MakeMKV and the live TV uses the hdhomerun extend, the media should direct play on the roku (other then other than the older MPEG2 dvd files i still have hanging around). Thanks! Erik Link to comment Share on other sites More sharing options...
Solution speechles 1917 Posted February 18, 2017 Solution Share Posted February 18, 2017 (edited) Here are some screenshots from blueneon app running on a roku ultra. 1) See the first screenshot for supported container/codecs 2) DCA is all the roku supports for dts, the dts core audio. The roku does not decode this, it is pass-through only. Note: in the [audio decode info] section DTS is missing because my TV doesnt decode it. If my TV did, the roku wouldve detected this, and DTS: 6:0:0:1 wouldve shown in that section. Edited February 18, 2017 by speechles 1 Link to comment Share on other sites More sharing options...
Erik 120 Posted February 18, 2017 Author Share Posted February 18, 2017 Thanks @speechless My TV doesn't support DTS either, so i guess emby would transcode the audio on most of my media. Have to look at the other devices maybe. thanks again. Link to comment Share on other sites More sharing options...
Happy2Play 8242 Posted February 18, 2017 Share Posted February 18, 2017 Converting audio doesn't require a lot of resources and almost every device is going to do the same with audio. 1 Link to comment Share on other sites More sharing options...
Erik 120 Posted February 18, 2017 Author Share Posted February 18, 2017 Understood. It's hard to move away from the full HTPC but it's overkill for a simple TV (I'll keep the full HTPC for the basement main viewing setup). I figure the Roku is the best option (as it's for Emby/Netflix/amazon prime) and no gaming (so don't need a shield) or is the shield that much better? Link to comment Share on other sites More sharing options...
Erik 120 Posted February 23, 2017 Author Share Posted February 23, 2017 (edited) Ok, so i got a roku ultra and its been going well. However, i find that emby is reducing the audio stream to MP3 with very low volume. @speechless, attached a pic of the device info (looks the same as your sample) if you have some insight? Thanks! and the remux log attached. Edited February 23, 2017 by Erik Link to comment Share on other sites More sharing options...
Happy2Play 8242 Posted February 23, 2017 Share Posted February 23, 2017 Does the Roku use the Downmix Transcoding option? Audio boost when downmixing: 1 Boost audio when downmixing. Set to 1 to preserve original volume value. Link to comment Share on other sites More sharing options...
Erik 120 Posted February 23, 2017 Author Share Posted February 23, 2017 I left it as default (1) on the server side. I didn't see any options within the preview app. (Unless that was directed @ebr) Link to comment Share on other sites More sharing options...
speechles 1917 Posted February 23, 2017 Share Posted February 23, 2017 (edited) The preview app has no options for this... The blueneon app has specific settings to choose which codec is used. It also allows you to choose aac, mp3, or ac3 and has the ability to transcode dts/dca to ac3 and keep surround sound. Does the TV you connected your roku support dolby? If not, the apps will detect this (via roku system audio settings) and will transcode all surround sound to stereo. To increase the decibel level when transcoding, use the server dashboard. Choose the transcoding tab, and set audio boost to 2. Every 3db doubles the sound pressure level. So 2 should be fine. Edited February 23, 2017 by speechles 1 Link to comment Share on other sites More sharing options...
speechles 1917 Posted February 23, 2017 Share Posted February 23, 2017 Uh ohhh.. Roku Ultra has a new firmware update 7.51.4095 to 7.51.4111 .. hmm Anyone updated to that build besides me? Sent from my Nexus 7 using Tapatalk Link to comment Share on other sites More sharing options...
Erik 120 Posted February 23, 2017 Author Share Posted February 23, 2017 Here is the spec sheet for the audio of the Sony TV. It says is supports DD. I will see if I alter the boost how it works. Thanks. Link to comment Share on other sites More sharing options...
Erik 120 Posted February 23, 2017 Author Share Posted February 23, 2017 @speechless, yes I'm on that new firmware (as I installed the Roku yesterday and it updated so all my testing has been on the new version) Link to comment Share on other sites More sharing options...
speechles 1917 Posted February 23, 2017 Share Posted February 23, 2017 (edited) You need to make sure your roku audio is set up correctly. System > Audio > HDMI Your HDMI setting should be set to dolby d+. Do not use auto as it causes issues. System > Audio > Audio Mode The audio mode setting should have auto chosen. Auto does not cause problems here. Once you change these... System > System Restart When the roku reboots back to the roku homescreen, turn off your TV, then turn it back on. This should restore hdmi/hdcp sync for the audio change. This should fix your situation, hopefully. *Crosses fingers* Sent from my Nexus 7 using Tapatalk Edited February 23, 2017 by speechles Link to comment Share on other sites More sharing options...
Erik 120 Posted February 23, 2017 Author Share Posted February 23, 2017 Ok thanks! I'll try that as soon I I get back home Link to comment Share on other sites More sharing options...
ebr 14903 Posted February 23, 2017 Share Posted February 23, 2017 The next update to the beta will transcode/preserve DD if supported by your device. Link to comment Share on other sites More sharing options...
Erik 120 Posted February 24, 2017 Author Share Posted February 24, 2017 @speechless I tried specifying the HDMI to DD and also tried DD+ (with a reboot and tv off/on) and in DD the video went all pixelated and unwatchable...and with DD+ it resulted in the audio being played funny (Only like a bass track or something...) I just ended up back at auto for now and see what the next beta ebr talked about does. Unless you have another idea! thanks. Link to comment Share on other sites More sharing options...
speechles 1917 Posted February 24, 2017 Share Posted February 24, 2017 Haw, then its the same issue I have. If set to DD+, the wrong sample rate is used. It isnt just a bass track. That is the sound s l o w e d down. What I did in the end is choose pcm stereo for hdmi, and stereo for audio mode. This still has the app detect dolby digital, and passes dolby digital the same. So something in rokus firmware is definitely broken in regards to roku ultra audio. Sent from my Nexus 7 using Tapatalk Link to comment Share on other sites More sharing options...
Erik 120 Posted February 24, 2017 Author Share Posted February 24, 2017 Ya, @@speechles i did the same (as you said, the auto setting seems to work the same as specifying PCM and stereo) so I put it back to auto for now to try the .18 release when it comes out, and the next firmware... I did change the downmixing level to 1.5 on the server side, that seems to keep all the different media within a few volume clicks of each other. Side question...Obviously you have a roku...what is you opinion on the nvidia shield tv... I'm just curious as I'm not completely sold on new roku yet (as the shield seems handles more video and audio formats it seems and less transcoding for the server) thanks again. Link to comment Share on other sites More sharing options...
ebr 14903 Posted February 24, 2017 Share Posted February 24, 2017 The Shield is pretty much the best you can do short of a full HTPC - but you do pay for it and you may or may not really need whatever additional perks the Shield may offer. Link to comment Share on other sites More sharing options...
Spaceboy 2493 Posted February 24, 2017 Share Posted February 24, 2017 The Shield is pretty much the best you can do short of a full HTPC - but you do pay for it and you may or may not really need whatever additional perks the Shield may offer.who doesn't want to play grand theft auto? [emoji1] Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now