Search the Community

Hi all, Is a week that I got the following problem, if I try to play from remote ,movie with bit rate 1080p H264 it start to play but stop each 2 or 3 sec and the processor load reach the value near or 100%.(I noticed the bandwith used is very very low) I'm quite sure before a week this was not happen. I have a terrramaster F2-220 with TOS at last release 4.1.03 and emby server 4.2.1.0 I 'm experimeting this problem just with the movie on 1080p H264 like this (see picture 1), other file 720p or lower working fine and reach sometimes the used bandwith around 1.7 Mb\s , so is not a network speed problem. If I set in the Emby android app ,the speed limit to 2 Mb\s it start to work, the bandwith used rich a pick to 800 kb\s, cpu always near 100%, but logically the quality of immage is sure poor than the original. I noticed also another aspect, if I try to reproduce a movies with 1080p but NOT H264 but HEVC the processor load remain quite low and the movie is played well without problem, the bandwith used arrive to a pick around 1Mb\s without problem.(see picture2 ) I wanted put the log but with file server app I'm not be able to see the folder were it stored on NAS, and I'm not familiar with SSH connection so I haven't included it. Hope I have given enought information for you expert :-) thx \Gianni Picture 1 BAD MOVIES Video Title1080p H264 CodecH264 AVCYes ProfiloHigh Livello41 Risoluzione1920x1040 Formato1.85:1 AnamorficoNo InterlacciatoNo Framerate23,976 Bitrate18.705 kbps Colori primaribt709 Spazio Colorebt709 Trasferimento Colorebt709 Profondità Bit8 bit Formato Pixelyuv420p Ref frame1 NAL4 . PICTURE 2 GOOD MOVIE Video Title1080p HEVC CodecHEVC ProfiloMain Livello120 Risoluzione1920x800 Formato2.40:1 AnamorficoNo InterlacciatoNo Framerate23,976 Bitrate3.193 kbps Colori primaribt709 Spazio Colorebt709 Trasferimento Colorebt709 Formato Pixelyuv420p Ref frame1 log emby server.txt log transcode.txt