Search the Community
Showing results for tags 'looping'.
Problem: transcoding a movie with 6-channel audio on a 2-channel (stereo) it TV causes the playback to loop, play a bit, then loop, then play a bit, then loop. This only starts to happen after an hour or so of the movie's playtime. If I fast forward a movie to an hour and ten minutes, the looping will happen. If I fast forward to the ten minute mark, or play ten minutes from the start, the looping will not happen. It only happens when I'm far into the movie. i've seen it happen with multiple movies after the hour (or so) mark. Server Platform: Raspberry PI 4 Server Version: Emby 4.3, and 4.4 beta. (I never saw this happen on 4.1... not sure about 4.2) Affected Apps: Emby on TCL TV with Roku Software, Roku Stick, old Roku box. Unaffected: Emby app on Samsung Galaxy, Emby played through a browser on a few laptops I've tried. I'm guessing transcoding is not happening so those are unaffected. I did not notice this happening until recently after I upgraded emby to 4.3 (from 4.1 or 4.2... sorry I don't recall the version I was using) and upgraded the hardware to a Raspberry PI 4 from a 3. I tried upgrading from 4.3 to the 4.4 beta, but the problem persists. I've tried adjusting transcoding settings, a variety of ways, including turning on and off hardware transcoding. Nothing seems to make any difference. The frequency of the looping happens roughly every few seconds at the max, and a high volume of ffmpeg-remux logfiles get generated. I've uploaded the server logfile, and several of the ffmpeg-remux log files (there are around 20 per minute generated sometimes) embyserver.txt ffmpeg-remux-1227e031-e60a-498d-bb6a-2a0dd5c5c08b_1.txt ffmpeg-remux-bf700119-a27c-4a9c-9a75-0bb32017e6cd_1.txt ffmpeg-remux-c82537e4-2b42-45fc-b58a-dc9439cac80b_1.txt hardware_detection-63713319499.txt